Lupe Hodge. Sink. January 28th , 2018.
After you clean the ridge, apply the silicone sealant: To the sink lip, apply the thin layer of silicone sealant. After the silicone sealant has been applied, place the undermount sink in from beneath. Center the kitchen sink stainless steel into position under the granite,
Having finished the sink, let's talk about the faucet. The primary material of the faucet is stainless steel and copper faucet. First, speak of the copper faucet. Non-standard copper, the domestic use of the most low-cost faucet is this, will precipitate a lot of harmful substances.
And the thickness of the pelvic sink floor is best to reach 1mm. Sink welding quality, close, no Weld is the key factor affecting the service life of the sink, sink the thinner work, the higher the degree of superb, with the table with the higher degree of fit, so when the tank to pay attention to its thin edge flatness.
The last step in installing the silk undermount stainless steel is to install the fittings. If you have confirmed the wing nuts are in place, stick masking tape to the back of the countertop. Mark the position to provide for the faucet after which you install the fittings.
Next to fitting the sink is drilling holes: When the kitchen sink stainless steel is in place, mark the portions where the holes of the undermount sink needs to be drilled on the granite countertop. Take the silk undermount stainless steel out and use a drill to introduce holes in the marked spots.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does Fair claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.